Please click “Read More” for details.
Click “Read More” for instructions to install your GIT-1 sensor.
The CommBox-600 is equipped with four (4) 50Amp 3-Phase relay contactors. This means that at 2-phase, you can connect up to 200 Amps worth of power, but at 3-phase, you can connect 150A per contactor. The relays are rated for 120-600 volts so the CommBox can be wired for 208, 277 and 480 using 3-Phase.
This page describes the ETO2 Controller and how it requires the installer to wire an external relay to connect the heaters/load to operate.
This Relay-25 fits in a standard single gang box. It is used in conjunction with the 4iE® Smart thermostat series as well as the Tempo thermostat, in order to expand the original 15 amp capacity. It is specifically designed for large applications beyond 800 sqft.
If it is not installed in the floor, the joint may give and your system will no longer work. Not only will your warranty be voided but you will have to repair the joint and place it back into the floor. The joint connects the heated wire to the unheated lead. NEVER leave the factory joint exposed to air and do not place it in or behind the wall.
No, the ASE series does not have built in GFCI. Please click “Read More” for details.
This page discusses the recommended practices of installing Warmup mats or cables in a shower.
Out of the box, no. Each ‘box’ will need its own sensor to trigger. Click “Read More” for more details.
The BOX system can be used with single-phase electric power. Click “Read More” for details.